![]() Now, place some stock under the fence and confirm the blade will cut all the way through. Lower the saw until it touches the saw and then raise it up just a bit to give plenty of clearance. (1) The saw motor and any other parts should clear the fence at your desired depth. There are a couple of considerations to think through before you build this jig. Over time the edge becomes uneven and it’s hard to line the track up. They also work pretty well, but they don’t fit perfectly and have some slop (move side to side enough to change the cut a bit) in them. There are retro-fit products available that turn your circular saw into a track saw. I’ve used one quite a bit, but you introduce an extra measurement and that’s another opportunity for error. There are straight-edges available that clamp, and they work great, but you have to account for not only the measurement of the piece you’re cutting, but also the distance on your saw from the blade to the edge of the base. I’ll also explain the other options out there and their problems. So, I’m showing you how to build one yourself, as I build mine. The best way I’ve found is to use a circular saw and some sort of straight-edge. I’ve done it on my table saw, but it’s a 2 person job and even then it’s a pain. Breaking down plywood is an issue for most hobbyist woodworkers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |